Light (Led); Tips For Saving Energy - Bosch KSF Serie Gebrauchsanleitung

en
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Taking out the door shelf "EasyLift"
Fig. 7
Move door shelf all the way upwards and
take out.
Removing the container
Fig. 8
Pull out the container all the way and lift
to detach it.
To insert the container, place on the
telescopic rails and push into the
appliance. Attach the container by
pressing it down.
Taking out the partition
Fig. 9/A
Pull the partition forwards and lift out.
Fig. 9/B
Lift the glass shelf out of the partition.
Remove telescopic rails
Fig. +
1. Pull out the telescopic rail.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear
pin.
4. Push telescopic rail together, push
backwards above the rear pin
and disengage.
Installing telescopic rails
1. Place the extended telescopic
rail on the front pin.
2. Pull the telescopic rail forwards
slightly until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards.
Removing cover from the door
ventilation
Fig. ,
Lift cover and remove from the door.
28

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Open the appliance as briefly as
■
possible.
Occasionally clean the rear
■
of the appliance to prevent an
increased power consumption.
If available:
■
Fit wall spacers to obtain the indicated
energy rating of the appliance (see
Installation instructions). A reduced
wall gap will not restrict the function
of the appliance. The energy rating
may then increase slightly.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.