Used Batteries; Assembling Instructions; Operation - FLORABEST IAN 71315 Originalbetriebsanleitung

When starting to charge and while
charging, the battery charge indicator
( 19) lights up red.
When charging is over, the light
changes to green.
1. Remove the battery (16) from the
appliance, as necessary.
2. Inser the battery (16) in the
charging compartment of the bat-
tery charger (19). It will audibly
snap in.
3. Plug the battery charger (19) into
a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (19) from the mains.
5. Press the release button (
on the battery (16) and pull the
battery out of the battery charger
(19).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").

Assembling instructions

Do not insert the battery until
the appliance is fully assem-
bled. Risk of injury!
To put on the protective
cover:
1. Place the protective cover (14) on
2. Pull the ends of the auxiliary han-
3. Screw down the screw (23) in the
4. Slip the cutting disc (12) onto the
17)
Spare cutting inserts are kept in the
box (4) on the auxiliary handle (5).
5. To insert the battery (16), place it

Operation

Caution: risk of injury! Do not
operate the appliance with-
out the protective cover. To
operate the appliance, wear
suitable clothing, eye and ear
protection.
Prior to every use, check that
the appliance is operative. Do
the motor head (10) and screw it
down with the 3 Phillips screws.
To put on the auxiliary
handle:
dle (5) to extend the handle and
slide it over the handle holder
(22).
auxiliary handle (5).
Mounting the trimming unit:
axle. There is only one mounting
position. Screw the cutting disc
(12) to the axle. Mind the left-
hand thread.
Place the cutting insert (13) on
the pin (23) on the cutting disk
(12) and pull out the insert until it
snaps in.
To insert the battery:
on the guide track (20) and push
it into the appliance. It will audi-
bly snap in.
GB
27