Supercool Function / Internal Parts - Küppersbusch IKEF 238-6 Gebrauchsanleitung

Starting the appliance
¥ The temperature setting buttons are located at the
top of the appliance on the control panel.
¥ Insert the plug into the plug socket.
¥ Press ON/OFF button (2).The green mains pilot
indicator (1) illuminates.
¥ The interior lighting comes on. The compressor
starts and then runs automatically. To switch off the
appliance, press the ON/OFF button (2) until the
display goes off.
¥ Press either the Ò+Ó (3) or Ò-Ó (5) button. The
temperature display switches over and the
DESIRED temperature currently set flashes on the
temperature display.
Temperature Control
¥ The temperature display is switched over from the
display of the ACTUAL temperature (temperature
display is illuminated) to the display of the
DESIRED temperature (temperature display
flashes) by pressing one of the two buttons, Ò+Ó (3)
or Ò-Ó (5).
¥ With each further press of one of the two buttons,
the DESIRED temperature is adjusted by 1¡C.
¥ I f neither button is pressed, the temperature
display automatically switches back after a short
period (approx. 5 sec.) to the display of the
ACTUAL temperature.
DESIRED temperature means:
The temperature that is required in the refrigerator,
this can be adjusted to the temperatures shown in
the display. The DESIRED temperature is indicated
by flashing numbers.
ACTUAL temperature means:
The temperature display indicates the temperature
that is currently present in the refrigerator. The
ACTUAL temperature is indicated by continuously
illuminated numbers.
In order for the appliance to run properly in certain
conditions a slight heating of the back surface of the
inner container can take place.
Temperatur display
The temperature display (4) can indicate several
pieces of information.
¥ During normal operation, the temperature currently
present in the refrigerator (ACTUAL temperature) is
displayed.
¥ When the temperature is being adjusted, the
temperature currently set flashes (DESIRED
temperature).
16
Supercool function
The Supercool function is suited for quick cooling of
large quantities of goods in the refrigerator, e.g.
drinks and salads for a party.
¥ The Supercool function is switched on by pressing
the Supercool button (9). The yellow light (8)
illuminates. The Supercool function now ensures
intensive cooling. A DESIRED temperature of +3¡C
is automatically selected. The Supercool function is
ended automatically after a period of 6 hours. The
originally selected DESIRED temperature is again
valid and the compartment will return to. The
temperature display shows the ACTUAL
refrigerator temperature.
¥ The Supercool function can be ended manually at
any time by pressing the Supercool button (9)
again. The yellow light (8) goes out.
Internal Parts
Storage shelves
¥ The shelves can be removed for cleaning.
¥ To permit storage of food packages of various
sizes, the shelves can be placed at different
heights.
¥ To remove the internal shelf pull forward until it can
be tipped up or down and removed.
¥ Please do the same in reverse to insert the shelf at
a different height.
¥ For better use of space, the front half-shelves can
lie over the rear ones.
D338