Starting The Appliance; Refrigerator Compartment -Starting The Appliance / Temperature Control / Internal Parts / Hints; Internal Parts - Küppersbusch ike 178-6 Gebrauchsanleitung

Starting the appliance

¥ The temperature regulator is located at the top of
the appliance on the control panel. It is also the
ON/OFF switch.
¥ A coin is required to turn the temperature regulator.
¥ Insert the plug into the wall socket and turn the
thermostat knob clockwise beyond position ÇOÈ
(OFF).
¥ The interior lighting comes on. The compressor
starts and then runs automatically. To switch off the
appliance, turn the temperature regulator to
position ÇOÈ.
Temperature Control
¥ The temperature regulator allows you to adjust the
temperature inside the refrigerator according to use
and external conditions.
¥ The following effects are of significance in respect
of the interior temperature:
¥ Ambient temperature
¥ Quantity and temperature of the food stored;
¥ Frequency with which the door is opened and
how long it is left open
¥ the location of the appliance.
¥ The temperature inside the appliance is
automatically adjusted.
¥ Setting ã1Ò = hightest temperature, warmest
setting
¥ Setting ã6Ò = lowest temperature, coldest
setting.
¥ Setting ãOÒ = Off
A medium setting is generally the most suitable.

Internal Parts

Storage shelves
¥ The shelves can be removed for cleaning.
¥ To permit storage of food packages of various
sizes, the shelves can be placed at different
heights.
¥ To remove the internal shelf pull forward until it can
be tipped up or down and removed.
¥ Please do the same in reverse to insert the shelf at
a different height.
12
D338
¥ For better use of space, the front half-shelves can
lie over the rear ones.
The glass shelf above the vegetable drawers
and the bottle shelf should always remain in
position, to ensure correct air circulation.
¥ To permit storage of food packages of various
sizes, the central door shelf can be adjusted in
height.
¥ Gradually pull the shelf in the direction of the
arrows until it comes free, then reposition as
required.
CP1OEM
¥ For more thorough cleaning, the top and bottom
door sheves can be removed by pulling them in the
direction of the arrows, then refitting them in
position.
Hints
Saving Energy
¥ Pay careful attention to where the cabinet is
placed. See the section ÒInstallationÓ. When
installed correctly the cabinet will consume less
energy.
¥ Try to avoid keeping the doors open for long
periods or opening the doors too frequently as
warm air will enter the cabinet and cause the
compressor to switch on unnecessarily often.
¥ If the ambient temperature is high, the thermostat
knob is on the coldest setting (higher numbers) and