Copyright; Before You Start; Setting Up And Assembling The Hot Water Dispenser - Silvercrest SHSD 2600 A1 Bedienungsanleitung

SilverCrest SHSD 2600 A1
device, the mains socket must still be easily accessible so that
you can remove the mains plug quickly in the event of an
emergency.
 Never immerse the heater unit (14) in water or other liquids.
If liquid does penetrate the heater unit (14), disconnect the
mains plug from the mains socket immediately and contact
our hotline (see "Warranty information" section).
DANGER: Risk of fire
 Fill the water reservoir (9) with at least 0.5 l of water. If
insufficient water is added, there is a risk of fire due to
overheating.
 Maintain a clearance of at least 20 cm around the hot water
dispenser to flammable and combustible materials. There is a
risk of fire.

5.1 Copyright

All the contents of this operating instructions are protected by copyright and provided to the reader
for information only. Copying data and information without the prior explicit written consent of the
author is strictly forbidden. This also applies to any commercial use of the contents and information.
All texts and diagrams are up-to-date as of the date of printing. Subject to change without notice.

6. Before you start

Unpack the device. First check whether all the parts are complete and undamaged. If any items are
missing or damaged, please phone our hotline (see "Warranty information" on page 20). Keep the
packaging material away from children and dispose of appropriately.

6.1 Setting up and assembling the hot water dispenser

WARNING
Only operate the hot water dispenser on an even, stable and heat-resistant
surface.
10 - English