Dispensing Hot Water - Silvercrest SHSD 2600 A1 Bedienungsanleitung

7.2 Dispensing hot water

DANGER: Risk of electric shock
Keep the heater unit (14) away from water. Otherwise there is a risk of lethal
electric shock.
WARNING
On the very first use, you need to rinse the device through and throw away
the water you heat (see previous section "Getting started").
WARNING
Always use fresh drinking water. Do not reboil any water that has cooled
down. Always pour away old water. Otherwise pathogenic germs could
form.
1. Check there is enough water in the water reservoir (9) (see "0.5L MIN" marking). If not, top up
with drinking water. Refer to the section "Filling the water reservoir" on page 12.
2. Place a cup, a mug or another heat-resistant container in the centre of the holder filter (13).
3. Press the unlock button (6) for at least 3 seconds to unlock the device. A beep sounds and the
temperature (1) and volume display (2) flash. At the same time, the water temperature (5) and
water volume (4) buttons light up.


4. If necessary, press the water temperature button (5) repeatedly to select the water temperature
you want.
5. If necessary, press the water volume button (4) repeatedly to select the water volume you want.
WARNING
Do not select a water volume which is greater than the capacity of the
container used. Otherwise, hot water can over-run and cause burns or
damage to property. If you are not sure, check the capacity of the
container first with a measuring jug.
6. Press the start button (3) to produce the set volume of hot water.
Press the start button (3) to cancel the filling process early.
7. The container placed on the holder filter (13) is then lit up and filled with water. Once the
process is complete, a series of beeps sound and displays (1) and (2) flash. When the unlock
button (6) is the only one still lit, you can remove the container from the holder filter (13).
The device saves the last water temperature (1) and water volume (2)
settings.
If you do not press a button for 15 seconds after unlocking the device, it
locks itself again.
SilverCrest SHSD 2600 A1
English - 15