Silvercrest SHSD 2600 A1 Bedienungsanleitung Seite 11

danger. There is a risk of electric shock in the case of a
damaged power cable (10).
 Do not open the heater unit (14) housing - it contains no
serviceable parts. Opening the housing can expose you to
the risk of electric shock.
 If you notice any smoke, unusual noises or strange smells,
unplug the mains plug from the mains socket. In these cases,
the hot water dispenser should no longer be used until it has
been inspected by authorised service personnel. Never
inhale smoke from a possible device fire. If you do
inadvertently inhale smoke, seek medical attention. Smoke
inhalation can be damaging to your health.
 Make sure that the power cable (10) cannot be damaged by
sharp edges or hot spots.
 Make sure that the power cable (10) cannot become
crushed or squashed.
 The device must always be disconnected from the mains
when left unsupervised and before assembly, disassembly or
cleaning.
 When disconnecting the power cable from the mains socket,
always pull on the mains plug and never on the power cable
(10) itself.
 If you notice visible damage to the hot water dispenser or the
power cable (10), switch the device off immediately,
disconnect the mains plug from the mains socket and contact
our hotline (see "Warranty information" section).
 Only connect the hot water dispenser to a properly installed,
easily accessible mains socket whose mains voltage
corresponds to that on the rating plate. After connecting the
SilverCrest SHSD 2600 A1
English - 9