Ironing Without Steam - Bosch sensixx B35L Gebrauchsanleitung

Fabric protection soleplate
cover (B)
(depending on the model)
The fabricbprotection soleplate cover is used for
steambironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for a
cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place the
tip of the iron into the end of the soleplate cover and
pull the elastic strap over the lower rear of the iron
until it fits tightly. To release the soleplate cover, pull
the elastic strap and remove the iron.
The fabricbprotection soleplate cover may be
purchased from the customer service or specialist
shops:
Accessory code
(Afterbsales)
571510
Ironing with steam (C)
1. Make sure that there is enough water in the
water tank
2. Turn the temperature selector (13) to the steam
position, between "••" and "max".
3. Set the amount of steam to suit your needs,
using the variable steam control (5)
4. Press the steam release button to release steam
(15)
Important:
• The steam hose may get hot if you are ironing for
long periods.

Ironing without steam

1. Begin ironing but without pressing the steam
release button (15).
Vertical steam (D)
1. Set the temperature control to the "•••" or "max"
position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing the
iron in a vertical position and pressing the steam
release button (15).
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
Name of accessory
(Specialist outlets)
TDZ2045
"Calc'n clean"
Cleaning the Boiler
To extend the life of your steam generator and
to avoid any build up of scale, it is essential that
you rinse out the boiler after several hours of use
(approximately after 50 hours). If the water is hard,
increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check that the appliance is cold and unplugged
for more than 2 hours, and that the removable
water tank (1) is empty.
2. Place your appliance on the edge of your kitchen
sink.
3. Remove the plastic cover located on the bottom
of the appliance by turning it to the
4. Unscrew the boiler drainage plug located on the
bottom of the appliance using a coin.
5. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water
6. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To
obtain the best result, we recommend that this
operation is done twice
Important: before rebclosing, make sure no
water remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin.
8. Insert and close the plastic cover by turning it to
the position.
Automatic clean warning
(depending on model)
Pilot light (3) will flash indicating that boiler must be
rinsed. To do this, follow the procedure described
in the section above.
To reset "Calc'n clean" pilot light and counter,
switch the station off twice, keeping it off during at
least 30 seconds each time
"Energy saving" button
(depending on the model)
If the "Energy saving" button (6) is switched on, you
can save up to 25% of the energy and 40% of the
water consumption, and still have a good ironing
result for most of your garments. It is advisable to
use the normal energy setting only for thick and
highly wrinkled fabrics.
en
position.
13