Ironing Without Steam - Bosch SensorSteam TDS12-Serie Gebrauchsanleitung

en
After the initial 1 minute period:
• The green lamp (5) stops lashing.
(clear light) goes on and starts lashing.
From this moment on, when the handle (1) of the
iron is gripped or if the steam activation button (2)
is pressed at steam setting:
stops lashing.
If the handle (1) is released:
lash
If the iron remains plugged in and is not used for
several minutes:
lashing.
Ironing with steam
The steam control is used to adjust the amount
of steam produced when ironing (see "setting the
steam amount" section).
1. Continuous steam generation :
2. Steam on demand :
continuous steam generation while gripping the handle
(1). On this setting, steam can only be produced
when manually pressing the steam activation button
(2) under the handle.
• Press the steam activation button (2).
Important :
"max".
• Adjust the temperature setting and then set the
steam control according to the table below. Steam
will automatically be produced:
Temperature control (15) setting
••
12
Ironing without steam
This enables the iron to be used for dry ironing.
• The temperature control (15) adjusts the temperature
• While ironing, do not press the steam activation
Spray
This can be used to remove stubborn wrinkles.
Shot of steam
This can be used to remove stubborn wrinkles or to
(4)
press in a sharp crease or pleat. It cannot be used
on a synthetic setting for delicate items.
Vertical steaming
This can be used to remove creases from hanging
" position, to cancel
clothes, curtains etc. It cannot be used on a
synthetic setting for delicate items.
Do not iron clothing while it is being worn!
Never spray or aim the steam at persons or
animals!
- between "••" and
• Hold the iron in an upright position about 15 cm away
• Press the steam activation button (2). The shot of
Steam setting
eco
setting.
of the soleplate (13). Set it to the corresponding
position by lining it up with the temperature index (14)
on the iron.
Select an appropriate temperature for the type of
material being ironed (see "setting the temperature"
section).
button (2).
Warning!
from the garment being steamed.
steam button (6) on the handle may be additionally
pressed at intervals of 5 seconds. However, after
4 shots of steam, wait for 10 seconds to allow for
continued steam production.
(5)
(6)
(7)
(8)
position.