Getting Ready; Ironing Without Steam - Bosch SensorSecure TDA 76-Serie Gebrauchsanleitung

en
To prolong the optimum steam function,
mix tap water with distilled water 1:1. If the
tap water in your district is very hard, mix
tap water with distilled water 1:2.
To prevent spillage of water out of the
appliance in vertical position, never fill
beyond the "max" water level mark!
Before using the iron for the
first time
Remove any label or protective covering
from the soleplate.
With the iron unplugged, fill in the tank
of the iron with tap water and set the
temperature control dial to "max"
Plug in the appliance to the mains. When
the steam iron has reached the desired
temperature (pilot light switches off), start
steaming by setting the steam regulator
to the maximum steam setting and by
repeatedly pressing the button
When using the steam function for the
first time, do not apply it on the laundry,
as there could still be dirt in the steam
dispenser.
When turned on for the first time, your
new iron may smell and emit a little smoke
and a few particles; this will stop after a
few minutes.
How to use the iron
Check the recommended
temperature in the label on the garment.
• Synthetics
•• Silk-Wool
••• Cotton-Linen
If you don't know what kind or kinds of
fabric a garment is made of, determine
the right ironing temperature by ironing a
part that will not be visible when you wear
or use the garment.
Start ironing the garments that require the
lowest ironing temperature, such as those
made of synthetic fibres.
Silk, wool or synthetic materials: iron the
reverse side of the fabric to prevent shiny
patches.

Getting ready

Remove any labels or protective coverings
from the soleplate.
10

Ironing without steam

Set steam control to the
Ironing with steam
Set temperature control to
the heating up, set the steam control to
or .
Set the temperature control to position
"••": steam control to
Set the temperature control to position
"•••" or "max": steam control to .
ProEnergy
(Depending on the model)
The "e" steam setting (energy saving "e"
setting: 24% energy saving*) can be used
for most fabrics. The
should only be used on thick fabrics where
there are still wrinkles.
.
Temperature
Setting
••• to "max"
••
*in comparison to the maximum steam
ironing
setting of a regular 2400 Watt max
Bosch iron
Note: At a temperature setting of "•", the
soleplate is not hot enough to produce
steam so the steam regulator should
be set to the
dripping from the soleplate.
Spray
Do not use the Spray function with silk.
Shot of Steam
Set the temperature control dial to at least
the "•••" position
Interval between shots of steam should be
5 seconds.
position.
and following
.
steam settings
Steam setting
e
Recomended Steam
Regulator Setting
e and
e
position to avoid water
(2)
(3)
(4)
(5)