Initial Use; Inserting The Batteries - Beurer EM 29 Gebrauchsanweisung

5. Initial use

Inserting the batteries

Open the battery compartment [4] by pushing the cover in the area marked with an arrow
and sliding downwards.
Insert the three alkaline AAA 1.5 V batteries. When inserting the batteries, ensure that the
correct polarity is observed.
Then close the battery compartment lid until you hear and feel it click into place.
Connecting the connection cable and positioning the universal cuff
1. Connect the connection cable with the metallic connection clips on the universal cuff.
Note
You can position the universal cuff on either your knee or elbow.
Before positioning the universal cuff, first clean the body parts to be treated.
Before positioning the universal cuff, first moisten the water contact
electrodes and the knee/elbow with water.
Position the universal cuff on your knee or elbow. At this point, ensure that the surfaces
of the water contact electrodes surround the knee/elbow. In doing so, the round ope-
ning of the universal cuff must lie on the kneecap/elbow tip.
2. Fix the universal cuff in the desired position using the hook-and-loop fasteners. Ensure
that the universal cuff is not too tight but that the water contact electrodes still have
sufficient contact with the skin.
3. Insert the plug for the connection cable into the connector socket [5] on the control
unit.
Replacing the battery
Please replace the batteries when the battery status symbol appears in the display [7].
• Open the battery compartment [4] by pushing the cover in the area marked with an
arrow and sliding downwards.
• 3 x 1.5 V batteries, type AAA (LR 03 Micro) should be inserted for operation.
Ensure the polarity is correct. Observe the graphic in the battery compartment.
• Do not use rechargeable batteries.
17