H) Transmission Of Settings - Conrad FS20 IRP Bedienungsanleitung

• The following illustration shows the complete macro programming for a channel (example).
Three different actors also receive three different commands here:
1141 actor 1 is supposed to dim to brightness stage 4 in 4 seconds (= "Ein (auf
Helligkeitsstufe 4 in)")
1142 actor 2 in 0.5 seconds to the previous set brightness (= "Ein (auf alte Helligkeitsstufe)
in")
1143 actor 3 is supposed to deactivate for approx. 25 minutes (= "Aus für")
1144 With a long press of the button (address xx44 corresponds to local master), all actors
are deactivated or dimmed down in 8 seconds (= "Aus in")

h) Transmission of settings

• To program an FS20 transmitter with the performed settings, put it into programming mode.
• To do so, press the keys "2" and "4" (check the operating instructions of the transmitter to
see where these keys are located!) for 5 seconds. Now the LED of the FS20 transmitter is
permanently lit. If no data is received, the programming mode quits after approx. 1 minute.
• No position the FS20 transmitter in such a way in front of the "FS20 IRP" that the transmitter
and receiver diode have direct "sight contact", meaning they are directly facing each other.
The maximum range of the "FS20 IRP" is approx. 30 cm; for a safe transmission, however,
the transmitter FS20 should be as close as possible to the "FS20 IRP".
• By pressing the button "FS20-Sender programmieren" (= "Program FS20 transmitter") in the
program window, the current settings are transferred by the software to the "FS20 IRP" and
from there to the FS20 transmitter.
• During transmission, the status LED "senden" (= "send") of the "FS20 IRP" lights up.
• As soon as the transmission was successful, the LED of the "FS20IRP" as well as the LED
of the FS20 transmitter go off.
However, if the LED blinks briefly and then goes off, there was a transmission error and the
device exits the programming mode.
36