Key Configuration - Conrad FS20 IRP Bedienungsanleitung


Note:
The software does not distinguish between different FS20 transmitters, as
transmitters with less than 10 keys ignore the superfluous settings.
For example, you only have to configure the first 8 keys for a transmitter
"FS20 S8", as the transmitter ignores all additional keys. Analog, this also
concerns the 4, 2 and 1-channel transmitters of the FS20 radio switching
system.
g) Key configuration
• The keys are configured via the input and selection fields. These are divided into 4 lines each
per key. Each line consists of an address, command, factor, basis and time field.
• With the first three lines, the addresses and the corresponding commands are set, which are
later on transmitted in sequence after a brief press of the button on the remote control.
• In the fourth line, you select the address and the command for the long press of the button.
• On the next page you will find an overview of the commands and their meaning.
Some commands can also be assigned activation or deactivation times. These times are
entered in the shape of a factor and a basic time and calculated as follows:
Time = factor x basis
The result is displayed in the field "Zeit" (= "time") and constantly updated.
• If you selected the option "aus" (= "Off") as factor, only the command without time is
transmitted when pressing the button.
Depending on the selected command, you can also select the entry "endlos" (= "endless")
or "sofort" (= "immediately") in the field "Faktor" (= "Factor"). These commands are then
executed immediately by an actor (meaning: FS20 receiver), or the actor remains in this
status after executing the command.
• The commands "Aktor-Timer programmieren" (= "Program actor timer"), "Einschaltrampe
programmieren" (= "Program activation threshold") and "Ausschaltrampe programmieren"
(= "Program deactivation threshold") are configuration commands that program the internal
timers of an actor.
34