C) House Code; D) Text Field "Notices; E) Saving/Loading; F) Key Selection - Conrad FS20 IRP Bedienungsanleitung

c) House code

• Via the input field "Hauscode" (= "House code"), you enter the house code that is valid for
the entire remote control if you do not want to apply the house code generated by the
program.

With the already available FS20 transmitters (see chart on chapter 1), the house
code is applied after a hardware reset. This means that you have to interrupt the
power supply of the transmitter after programming (remove the batteries or
disconnect the power pack unit).
• To trigger a safe reset, now press a button to discharge the available electric contacts.
Afterwards, connect the voltage supply again (reinsert the batteries or reconnect the power
pack unit).

d) Text field "Notices"

• The large text field "Hinweise" (= "Notices") serves as an information field. It displays help
texts for the selected commands in dependence on the current settings.

e) Saving/loading

• With the button "Speichern" (= "Save"), you save the performed settings in a separate file.
• With the button "Laden" (= "Load"), you can reload already saved key assignments into the
program.

f) Key selection


To enable support for the handheld remote control "FS20 S20", you have to
distribute the input and selection fields for the keys to three "pages".
• You can switch between these "pages" with the checkboxes in the field "Tastenauswahl"
(= "Key selection"). By default, the keys 1 to 8 are selected after starting the software.
• The keys 9 to 16 are located on the second page, and the keys 17 to 20 on the last page.
33