Sleep Function; Alarm Function - Renkforce 1423783 Bedienungsanleitung

f) Sleep function
• When listening to the radio (FM or AM), you can activate the sleep function by push-
ing the button "SLEEP" (A3).
• If you push the button for the first time, the display will show "15" and flash. After
approx. 2 seconds, the display will automatically switch back to the time. The Sleep
function is then active and the radio will switch off after 15 minutes.
Push the button "SLEEP" (A3) twice to show "30" for a 30-minute-timer in the display.
When pushing three times, the timer is set to 60 minutes (maximum).
• Once the function is active, the display shows "SLEEP" (C8).
• While the function is active, you can push the button "SLEEP" (A3) once to have the
remaining time displayed in minutes.
• To terminate the function prematurely, push the button "SLEEP" (A3) repeatedly until
the time is displayed again and the text "SLEEP" (C8) has disappeared.
g) Alarm function
Set alarm time
• To set an alarm time, keep the button "ALARM SET" (B4) pushed for 2 seconds so that
the hours of the alarm time start to flash.
• Set the hours of the alarm time with the arrow buttons B6 (down) and B7 (up). Keep
the respective button pressed for quick adjustment.
• Briefly push the button "ALARM SET" (B4); the display of the alarm time minutes will
flash. Set the minutes of the alarm time with the two arrow buttons B6 (down) and B7
(up) as well.
• Push the button "ALARM SET" (B4) again briefly to leave the setting mode and save
the alarm time.
If you do not push any button for approx. 30 seconds, the setting mode is left
as well and the currently set alarm time is saved.
46