Renkforce 1423783 Bedienungsanleitung Seite 47

Switch alarm function On/Off
Use alarm function with signal sound:
• To switch on the alarm function, move the switch A12 at the bottom of the right side
from "OFF" to "ON".
Using the alarm function with the radio:
• Switch on the radio with the button A1.
• Choose the desired transmitter via a station button or manually, and set the desired
volume with the switch ("VOL +") (A10) or ("VOL -") (A11).
• Switch the radio off again with the button A1.
• To switch on the alarm function, move the switch A12 at the bottom of the right side
from "OFF" to "RADIO".
The following applies to both methods:
• Next to the radio tower symbol (C9), a small bell symbol (C7) appears, showing wheth-
er the alarm function is switched on or not.
Snooze function (Snooze)
• When the alarm signal sounds or the radio switches on (the bell symbol C7 flashes),
briefly push the button "SNOOZE/LIGHT" (A2) on the top of the radio projection alarm
clock.
The alarm signal or the radio is interrupted for approx. 5 minutes and then restarted.
You can repeat this as often as you like for 24 hours.
• You can end the snooze function prematurely by pushing the switch A12 from "RA-
DIO" or "ON" to "OFF". The bell symbol C7 stops flashing.
Stopping the Alarm Signal
• When the alarm signal sounds at the set alarm time or the radio start up, move the
switch A12 from "RADIO" or "ON" to "OFF". The bell symbol C7 stops flashing.
The alarm signal sounds for 1 minute and the radio is on for 30 minutes.
As soon as the respective time is elapsed, the alarm signal or the radio is
switched off automatically. As long as the A12 switch remains in position
"RADIO" or "ON", the alarm is enabled permanently and switches on every
day at the same time.
47