Problem Solving - RUSTA AUSTIN Gebrauchsanleitung

ENG
STORAGE
• Clean all surfaces.
• When cool and not in use, store your smoker indoors in a dry location to protect against rusting.
• If storing the smoker outdoors, cover the smoker with a smoker cover for protection from the
weather.
PROBLEM-SOLVING
PROBLEM
Burner
Fire at control
knob
Yellow flames at
burner
Flame blow out on
"Low"
Burner does not
get hot enough
Smoker is too hot
8
POSSIBLE CAUSES
Check LP cylinder fuel level.
Bad electrode spark.
Burner may not be properly
seated.
Burner may be obstructed.
The cylinder valve may be closed.
Regulator is not properly seated
on cylinder valve.
Burner holes may be obstructed.
Burner is improperly seated on
control valve.
Gas connections may be loose.
Burner is obstructed.
Burner holes may be obstructed.
Burner is improperly seated on
control valve.
Grill is not sufficiently pre-
heated.
Flow control device has been
activated in regulator.
Excess grease build-up causing
grease fires.
Damaged or faulty regulator.
Cook on a lower temperature.
ACTION
Replace LP Cylinder.
Check to see if the smoker will match
light. Electrode or collector may need
adjustment.
Reseat burner.
Clear obstructions from burner.
Open cylinder valve.
Reseat regulator on cylinder valve.
Clear obstructions from burner.
Reseat burner on control valve.
Leak check and tighten all connections.
Clear obstructions from burner.
Clear obstructions from burner holes
Reseat burner on control valve.
Pre-heat smoker sufficiently.
Reset regulator by turning off gas at
LP cylinder. Disconnecting regulator
from tank. Re-attaching regulator to
tank.
Clean smoker components thoroughly.
Replace with factory authorized parts.
Lower flame height and temperature.