Connecting The Terminal Board The Appliance Incorporates An Easily - Electrolux EON 33000 Gebrauchsanleitung

does not reach at any given point a
temperature 50°C higher than the ambient
temperature.
Suitable power supply cables are the following
types, considering the respective necessary
section of cable: H07 RN-F, H05 RN-F, H05
RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F.
Connecting the terminal board
The appliance incorporates an easily
accessible 6-pole terminal board whose
jumpers (bridges) are already pre-set for
operation on 400 V tri-phase with neutral wire
(Fig. 19). In case a different mains voltage is
present, the jumpers on the terminal board
must be rearranged as shown in the diagram
(Fig. 20). The ground cable must be
connected to terminal
the supply cable to the terminal board, secure
it with a junction clamp.
Electrical connection with the
hob
This oven can be connected to hobs
indicated in the paragraph "Technical data".
The socket for connecting the hob is located
at the top of the oven cabinet. The hobs
come complete with connecting leads for
the hot plates/heat areas and ground cable;
these leads feature plug-in connectors.
Connection of the hob to the oven is carried
out by plugging-in these connectors to the
corresponding oven socket.
The plug-to-socket connection design is
such as to prevent possible wrong
plugging-ins.
The Manufacturer disclaims any
liability in
accident-preventing rules are not
observed.
. After connecting
case these
1 2 3 4 5
230V 3~
L1 L2
1 2 3 4 5
230V 1~
L1
1 2 3 4 5
400V 2N~
L1 L2
1 2 3 4 5
400V 3N~
L1 L2 L3 N
electrolux 59
Fig. 19
L3 PE
N PE
N PE
PE
Fig. 20