Care And Cleaning; What To Do If - Electrolux ESL 68071 Benutzerinformation

Programme
PREWASH
1) The display shows the programme time.
The water pressure and temperature,
the variations of the mains supply and

CARE AND CLEANING

To remove and clean the filters
Dirty filters decrease the washing results.
Although the maintenance is very low with
these filters, make a check at intervals and
if necessary, clean them.
1. Turn the filter (A) counterclockwise and
remove it out from filter (B).
B
A
2. Filter (A) has two parts. To disassemble
the filter, pull them apart.

WHAT TO DO IF...

The start of the appliance does not occur or
it stops during operation.
1)
Energy (kWh)
0,1 4
the quantity of dishes can change the
consumption values.
3. Fully clean the parts with water.
4. Put the two parts of the filter (A) togeth-
er and push. Make sure that they assem-
ble correctly in each other.
5. Remove the filter (B).
6. Fully clean the filter (B) with water.
7. Put the filter (B) to its initial position.
Make sure that it assembles correctly in
the two guides (C).
8. Put the filter (A) into position in filter (B).
Turn the filter (A) clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
electrolux 13
Water (litre)
C