Setting And Starting A Programme; Setting Mode - Electrolux ESF6535LOX Benutzerinformation

7.1 Using the detergent
D A B
30
20
A B D
3 0
2 0
7.2 Setting and starting a
programme
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance a few minutes after:
• You have not closed the door.
• You have not pressed Start to start the
programme.
• The programme is completed.

Setting mode

For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when,
after the activation, the indicator and the
duration of the programme ECO are on.
If the control panel does not show this
condition, press and hold, at the same
time, Program and Option until the indi-
cator and the duration of the programme
ECO come on.
1.
2.
3.
4.
C
5.
A
-
+
C
Press the release button (B) to open
the lid (C).
Put the detergent in the compartment
(A) .
If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
If you use detergent tablets, put the
tablet in the compartment (A).
Close the lid. Make sure that the re-
lease button locks into position.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. The indicator and the dura-
tion of the
on.
3. Close the appliance door.
4. Set a programme.
• If you want to start the
gramme, press Start.
• If you want to set a different pro-
gramme, press Program again and
again until the indicator of the pro-
gramme you want to set comes on.
You can also set the applicable op-
tions.
The display shows the duration of the
programme.
5. Press Start to start the programme.
• The washing phase indicator comes
on.
• The programme duration starts to
decrease with steps of 1 minute.
ENGLISH 29
programme come
pro-