Options; Energysaver; Acoustic Signals - Electrolux ESF6535LOX Benutzerinformation

Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

5. OPTIONS

Activate or deactivate the options
before the start of a programme.
You cannot activate or deactivate
the options while a programme
operates.
If one or more options are set,
make sure that the related indica-
tors are on before the programme
starts.

5.1 EnergySaver

This option decreases the temperature in
the last rinse phase.
The use of this option decreases the ener-
gy consumption (up to 25%) and the pro-
gramme duration.
The dishes can be wet at the end of the
programme.
How to activate the EnergySaver
option
1. Press Option until the EnergySaver in-
dicator comes on. In the display you
can see the update of the programme
duration.
• If the option is not applicable to the
programme, the related indicator
does not come on.
5.2 Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the use of rinse
aid and salt. The related indicators stay
off.
The programme duration can increase.
How to activate the Multitab option
1. Press the on/off button to activate the
appliance.
2. Press Option until the Multitab indica-
tor comes on.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse
aid.

5.3 Acoustic signals

The acoustic signal operates when the
appliance has a malfunction. It is not pos-
sible to deactivate this acoustic signal.
There is also an acoustic signal that oper-
ates when the programme is completed.
By default, this acoustic signal is off, but it
is possible to activate it.
How to activate the acoustic signal
for the end of programme
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a programme".
2. Press and hold, at the same time, De-
lay and Start until the programme in-
dicators ,
start to flash.
3. Press Delay.
• The programme indicators
and
•
The programme indicator
tinues to flash.
• The display shows the current set-
ting.
ENGLISH 25
and
go off.
con-