Inhaltsverzeichnis
Werbung
16.1 Messages
Messages
No basic unit identified
No piston fitted
Special cleaning position case:
If the basic unit is in cleaning position, mounting can be facilitated by moving the spindle slowly to the lower stop by
pressing the "Move" button in the message on the control unit for a longer period of time. If the spindle is already at the
lowest point, pressing the button for a longer period will move it slightly upwards again.
Reason
- Basic unit not connected to control
unit
- Basic unit was assembled without
piston
Solution
- Check cable connection.
- Dismantle basic unit and fit piston
again.
73
Werbung
Inhaltsverzeichnis
