Rack With Clips - Heidolph UNIMAX 2010 Betriebsanleitung

Slip clamping rollers over holding bars (3), push against the vessel to be clamped, and Slip clamping rollers over holding bars (3), push against the vessel to be clamped, and
secure with wingbolts (5). secure with wingbolts (5).
clamping roller
(P/N 549-58000-00)
base frame
(P/N 549-50000-00)
Attaching one more row of vessels requires installation of extra clamping rollers. Attaching one more row of vessels requires installation of extra clamping rollers.
Before starting shaking, make sure all vessels and clamping rollers are safely locked
in place and all screws of the universal mount have been pulled tight as specified.
3.2. Rack and holding clamps for Erlenmeyer flasks
This rack with appropriate clamps allows to safely hold Erlenmeyer flasks of even different
sizes on the shaker plate.
Components: rack, P/N 549.59000.00 plus clamps (quantity as required):
•
for 25 ml Erlenmeyer flask
•
for 50 ml Erlenmeyer flask
•
for 100 ml Erlenmeyer flask max. 23 ea. per rack, P/N 549.53000.00
•
for 250 ml Erlenmeyer flask max. 12 ea. per rack, P/N 549.54000.00
•
for 500 ml Erlenmeyer flask max. 9 ea. per rack, P/N 549.55000.00
•
for 1000 ml Erlenmeyer flask max. 5 ea. per rack, P/N 549.56000.00
Distribution of holes in the rack permits whatever combination of clamps.
The only restriction is to arrange clamps in a manner avoiding direct contact between each
other; moreover, flasks should not protrude over the edge of the shaker plate.
How to install clamps:
•
Remove nuts (3) and washers (2) from clamp bolts (1).
•
Plug clamp (1) in rack hole and secure with washer (2) and nuts (3); tighten with box-end
spanner (4) from hardware bag.
•
25 to 100 ml clamps feature a threaded bolt, whereas 250 - 1000 ml clamps use four each
bolts.
Locate rack with clamps installed on shaker plate.
max. 36 ea. per rack, P/N 549.51000.00
max. 36 ea. per rack, P/N 549.52000.00
21 21
IEI