Remote Control Operation - Sharp FU-40SE Bedienungsanleitung

REMOTE CONTROL
OPERATION
• To start operation, press the ON/OFF button.
A short beep will sound and operation will start in the
AUTO mode.
• To stop operation, press the ON/OFF button again.
A long beep will sound and operation will stop.
Transmitter
Manual (fan level)
button
The fan level can be switched
between Silent, Median, High
and Max.
Silent operation but-
ton
Operation will be in the Silent
mode with little air.
* Tobacco smoke re-
moval operation but-
ton
Unit will operate effectively
when smoking cigarettes, etc.
ON/OFF button
Used to start AUTO operation
(short beep) and stop opera-
tion (long beep).
Filter reset button
Press this button after replac-
ing the filters.
It can't remove the noxious
*
substances (carbon monoxide
etc.) of cigarette.
Cluster ion select button
AUTO cluster ion button
The unit will switch between the Clean mode and
Refresh mode automatically depending on the
amount of pollution in the air (dust sensor).
Clean button
The unit will constantly operate in the Clean
mode. The Clean mode is effective for removing
mold fungus in the air.
(Cluster ion lamp on (blue))
If the room smells especially moldy, operate the unit in the Clean mode.
FU-40SE
RESET
Plasmacluster
AUTO OFF
AIR PURIFIER
OFF button
The generation of ions is stopped and the
cluster ion lamp is turned off.
Refresh button
The unit will constantly operate in the Re-
fresh mode. The Refresh mode maintains
the balance of ions in the air for a refresh-
ing effect.
(Cluster ion lamp on (green))
E-11
Operations available with
remote control
• Fan level manual opera-
tion
• Fan level AUTO operation
• Silent operation
• Max operation
• Tobacco smoke removal
*
operation
• Pollen removal operation
• OFF timer setting
• Cluster ion select
AUTO cluster ion
Clean mode
Refresh mode
AUTO (fan level) but-
ton
The fan level switched auto-
matically depending on the
amount of pollution in the air.
Max operation button
Used to quickly clean the air in
the room.
Pollen removal opera-
tion button
The unit operates effectively
when you suspect pollen in the
air.
OFF timer button
Used to set the OFF timer.
The set time switches every
time the button is pressed as
shown below.
1 hour
4 hours
8 hours
Cancel
• The remaining time is indi-
cated by the lamp as time
passes.
• The unit will stop operation
when the timer is up.
At the start of operation, the
Cluster ion mode is also set
to AUTO.