Disposal And Recycling; Troubleshooting; Possible Cause - Scheppach Hs120 Originalbetriebsanleitung

14. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can
be reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and
plastics. Take defective components to special waste
disposal sites. Check with your specialist dealer or
municipal administration!
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point.

15. Troubleshooting

Problem
Saw blade gets loose after
turning off the motor.
Motor does not start.
Motor has wrong direction of
rotation.
Engine does not provide pow-
er, the fuse triggers.
Burns on the cutting surface
with longitudinal cuts with
cross cuts.
30 | GB

Possible cause

Fastening nut tightened insufficiently. Tighten fastening nut, right-handed thread.
Mains fuse failure.
Extension cable defect.
Connections on the motor or switch
defect.
Motor or switch defect.
Defective capacitor.
Wrong connected.
Cross-section of the extension line is
not sufficient.
Overload by blunt saw blade .
Blunt saw blade.
Wrong saw blade.
www.scheppach.com
This can be done, for example, by returning it
when purchasing a similar product or delivering it
to an authorised collection point for the recycling
of old electrical and electronic devices. Improper
handling of waste equipment may have negative
consequences for the environment and human health
due to potentially hazardous substances that are often
contained in electrical and electronic equipment.
By properly disposing of this product, you are also
contributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Help
Check mains fuse
See „Electrical connection" in the operating
manual.
Have it checked by an electrician.
Have it checked by an electrician.
Check by qualified electrician.
Exchange the polarity of the wall socket by qual-
ified electrician.
See „Electrical connection".
Change saw blade.
Insert a sharpened saw blade.
Change saw blade.