How To Handle Basic Operations; Picture Adjustment - JVC LM-10W Bedienungsanleitung

HOW TO HANDLE BASIC
OPERATIONS
BASIC OPERATION
1. Press the POWER (
power.
POWER
2. Press the INPUT SELECT buttons to choose input.
INPUT SELECT
A B Y/C
3. Press the VOLUME/SELECT buttons to adjust the
speaker volume.
VOLUME/SELECT
– +

PICTURE ADJUSTMENT

1. Press select buttons corresponding to the item
you want to adjust.
PHASE CHROMA BRIGHT CONTRAST
2. Adjust with the VOLUME/SELECT buttons.
VOLUME/SELECT
– +
6
) button to turn on the
Push : Turns the power on. (The Power button lights
green.)
Push again : Turns the power off and activates the stand-by
mode. (The Power button goes out.)
Select video signals input to terminals on the rear panel. The
selected INPUT SELECT button lights in green.
I
NPUT
Terminals on the rear panel
SELECT
Video signal input
button
1
Input A VIDEO A terminal
2
Input B VIDEO B terminal
3
Input Y/C VIDEO Y/C terminal
Press this button to display the speaker volume level on the
screen.
+ : The Built-in speaker volume is increased. (0 = 50)
– : The Built-in speaker volume is decreased. (50 = 0)
* Screen indication will disappear about 10 seconds after
operating.
The item you select is displayed on the screen.
1
PHASE ( )
2
CHROMA ( )
3
BRIGHT ( )
4
CONTRAST ( ) : Contrast control
VOLUME/SELECT buttons
Items
PHASE
reddish
(Phase)
CHROMA
lighter
(Chroma)
BRIGHT
darker
(Brightness)
CONTRAST
(Contrast)
* Screen indication will disappear about 10 seconds after operating.
Audio signal input
AUDIO terminal
: Phase control
: Chroma control
: Brightness control
– +
greenish
deeper
brighter
lower higher
STATUS indication
(PAL or NTSC)
PAL
About the STATUS indication
● With the COLOR SYSTEM setting set
to AUTO mode, when you turn on the
power or select inputs, the colour
system indication appears for about
3 seconds on the screen while PAL or
NTSC signals are being detected.
It does not appear when receiving a
B/W signal or when no signal is input.
Refer to page 7 for more information
about COLOR SYSTEM setting and
page 8 for more information about
STATUS indication setting.
0
VOLUME : 20
–
– 40 +
PHASE : 20
–
Notes:
● Phase control is effective only in the
NTSC colour system mode.
● Chroma control is not effective when
receiving B/W or when no signal is
input.
● When CHROMA is adjusted to "–40,"
the picture becomes less colourful.
● "NO EFFECT" is displayed (for about
3 seconds) when your selected
function has no effect.
50
+
40
+