JVC LM-10W Bedienungsanleitung Seite 11

Set-up menu items
H. POSITION
V. POSITION
WHITE BALANCE
DRIVE R.DRIVE
B.DRIVE
CUT OFF R. CUT OFF
G. CUT OFF
B. CUT OFF
CONTROL LOCK
STATUS DISPLAY
4. To set the other set-up menu items, repeat the
procedures 2 and 3.
5. Press the MENU button to quit.
Front panel
MENU
button
MENU
Purpose
Adjusts the horizontal position of
the screen (+ : Horizontal position
shifts to the right/–: Horizontal
position shifts to the left)
Adjusts the vertical position of the
screen (+: Vertical position moves
down/–: Vertical position moves up)
Adjusts the white balance
Adjusts red level
Adjusts blue level
Adjusts red cut off
Adjusts green cut off
Adjusts blue cut off
Sets the operation buttons on the
front panel to control lock mode
Sets the status display of the colour
system
Function
displayed
Quit (or Release) the <MENU>
EXIT
screen
Settings
–10 ~ 0 ~ 10
–10 ~ 0 ~ 10
Selects DRIVE (DRV) or CUT OFF (CUTO) adjustment.
Screen setting is changed to the selected setting mode.
Select R/G/B buttons corresponding to the function display
to adjust.
–20 ~ 0 ~ 20
–20 ~ 0 ~ 20
–20 ~ 0 ~ 20
–20 ~ 0 ~ 20
–20 ~ 0 ~ 20
OFF ON
ON OFF
Contents
Notes:
● When the CONTROL LOCK function is
set to ON, pressing operation buttons
on the front panel will display the
message "CONTROL LOCK ON!" on
the screen for about 3 seconds.
● The CONTROL LOCK function is
maintained even when the power is
turned off.
● To turn off the CONTROL LOCK
function, while holding the MENU button
press the PHASE button. Then set the
CONTROL LOCK function to OFF.
● Even when the CONTROL LOCK
function is set to ON, the following
operations are available:
– Volume control with the VOLUME/
SELECT buttons
– Display or disappear of the <SET-UP
MENU> screen.
● The STATUS DISPLAY function can be
set to display (ON) or not display (OFF)
the present colour system when the
power is turned on or the input signal is
changed. Refer to page 6 for more
information.
9