Unpacking; Before Commissioning; Working Instructions; Start-Up - Scheppach Ab1600 Originalbetriebsanleitung

Additional information for power tools
m WARNING!
The vibration emission value specified has been meas-
ured in accordance with a standardised test procedure
and may change depending on the type and manner
in which the power tool is used and may be above the
specified value in exceptional cases. The specified vi-
bration emission value can be used to compare one
power tool with other.
The specified vibration emission value can also be
used for an initial assessment of the impairment.
Keep the noise level and vibration to a minimum!
• Only use faultless devices.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
• Wear gloves.

8. Unpacking

• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
24 | GB
9.

Before commissioning

Before connecting, make certain that the data on the
type plate matches with the mains power data.
Always pull out the mains plug before carrying out ad-
justments on the device.
• Familiarise yourself with your machine. Familiarize
yourself with its use and limitations, but also with the
specific potential hazards.
• Make sure that the switch is OFF before inserting
the plug into the socket.
• Make sure that the machine has been cleaned and
lubricated properly.
• Before commissioning, check the machine for dam-
aged parts and determine whether these parts func-
tion properly and fulfil their intended function. In cas-
es of doubt, the part in question must be replaced.
• Check the alignment of all moving parts, any broken or
fastening parts, and any other conditions which may
impede proper operation. Any damaged part must be
repaired or replaced by a specialist immediately.
• Do not use the machine if a switch cannot be
switched on and off properly.
m ATTENTION! Before the start of operation, check
the deployment location for hidden electrical lines, gas
pipes and water pipes using a cable detector.

10. Working instructions

• Only use faultless devices.
• Make all machine settings with the machine
switched off.
• Never leave the machine unattended when it is run-
ning.
• When shutting down, only leave the machine after it
has come to a complete standstill.
• Always switch the machine off before unplugging the
mains plug.
• Always unplug the mains plug. Never pull the plug
out of the socket using the cable.
• Maintain and clean the device at regular intervals.

11. Start-up

11.1 Inserting the chisel (Fig. B)
1. Always clean the chisel before inserting it and
lightly grease the shaft.
2. Pull out the locking bolt (6) up to the stop, rotate it
180° and release.
www.scheppach.com