VEVOR BBD-230L Originalanleitung Seite 13

4 Manual 1 pcs
Maintenance and cleaning
• Keep the surface of the cabinet clean, remove dust frequently. Do not
spray and rinse with water when cleaning, so as not to affect the insulation
performance of electrical appliances.
• When cleaning the product, cut off the power supply first, wipe gently with
soft cloth and water or use detergent, and then wipe the detergent with
water.
• In order to prevent damage to the protective layer of the appliance, it is
forbidden to use hard or sharp cleaning ware to clean the cabinet.
• Do not use acid, alkaline detergent, such as the oil, boiled water, brush
and other cleaning.
• After cleaning, plug the power and check the switch or thermostat in the
setting position.
• When the frost in the product is thick, remove the items in the cabinet and
open the door to defrost.
• When defrosting, do not use a metal sharp tool scraper, so as not to
damage the wall or puncture the refrigeration pipe.
• When not using the product for a long time, unplug the power plug, clean
the cabinet, close the door after fully drying, and cover with rubber bag.
• Repair and maintenance to electrical components shall include initial
safety checks and component inspection procedures. If a fault exists that
could compromise safety, then no electrical supply shall be connected to
the circuit until it is satisfactorily dealt with. If the fault cannot be corrected
immediately but it is necessary to continue operation, an adequate
temporary solution shall be used. This shall be reported to the owner of the
equipment, so all parties are advised.
• Initial safety checks shall include:
1) that capacitors are discharged: this shall be done in a safe manner to
avoid possibility of sparking;
- 12 -