Scheppach PM1200 Originalbetriebsanleitung Seite 22

6. Technical data
Rated voltage
Power consumption
Speed
Weight
Stirrer receptacle
Mixing rod (with mixing element)
(2) Ø max.
Acoustic emission
Noise emission values measured according to the rel-
evant standards.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
wA
Uncertainty K
WA
Vibration a
h
Uncertainty K
• The specified vibration emission value has been
measured according to a standardised testing pro-
cedure and can be used for comparison of one elec-
tric tool with another;
• The specified vibration emission value can also be
used for an initial estimation of the exposure.
• The vibration emission value can vary from the
specified value during the actual use of the electric
tool, depending on the type and the manner in which
the electric tool is used;
• Try to minimise stress from vibrations as low as
possible. Some examples of means for reducing the
vibration stress are wearing gloves while using the
tool and limiting work time. In the process all parts
of the operating cycle must be taken into account
(such as times in which the electric tool is switched
off or time in which it is switched on, but is not run-
ning under a load).
7. Unpacking
• Open the packaging and carefully remove the product.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
22 | GB
• Check the product and accessory parts for transport
220-240 V~ 50Hz
1200 Watts
• If possible, keep the packaging until the expiry of the
0-700 rpm
• Familiarise yourself with the product by means of the
5.7 kg
M14
• With accessories as well as wearing parts and re-
120 mm
• When ordering please provide our article number as
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
92 dB
tic bags, films or small parts! There is a danger of
3 dB
choking or suffocating!
100 dB
8. Assembly
3 dB
5.637 m/s²
m Attention!
1.5 m/s²
Always make sure the product is fully assembled
before commissioning!
1.
2.
m DANGER!
Only use a mixing rod that is suitable and de-
signed for the material to be mixed. An incorrect
mixing rod can damage the device due to over-
loading and cause accidents!
To remove, turn the mixing rod counterclockwise out of
the drive shaft. The rod can be very tight in this mount.
In this case, the mounting must be secured with a key
to prevent it from turning (Fig. 4).
m Warning!
Disconnect the machine from the power supply before
assembling or disassembling the stirrer.
Failure to do so may result in accidental starting and
possibly serious injury.
www.scheppach.com
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
warranty period.
operating manual before using for the first time.
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
well as type and year of manufacture for the product.
Turn the mixing rod (1) clockwise into the mixing
element (2) (Fig. 2).
Then screw the assembled mixing rod into the
drive shaft (3) (Fig. 3).