Clock Functions; Setting The Duration - Progress Pbd34101B Benutzerinformation

Fill the cavity embossment with water
only when the oven is cold.
CAUTION! Do not refill the
cavity embossment with
water during cooking or
when the oven is hot.
2. Put food in the oven and close the
oven door.
3. Set the function:
4. Turn the control knob to select a
temperature.

CLOCK FUNCTIONS

Clock functions table
Clock function
TIME OF DAY
DURATION
END
TIME DELAY
MINUTE MIND‐
ER
Setting the time. Changing the
time
You must set the time before you operate
the oven.
The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer is
not set.
Press the or
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time of day press
and again until
.
Application
To set, change or check the time of day.
To set how long the appliance operates.
To set when the appliance deactivates.
To combine DURATION and END function.
To set countdown time. This function has no effect on the op‐
eration of the appliance. You can set the MINUTE MINDER at
any time, also when the appliance is off.
to set the correct time.
again
starts to flash.
5. Turn the knob for the heating functions
to the off position to turn off the oven.
6. Remove water from the cavity
embossment.
WARNING! Make sure that
the oven is cold before you
remove the remaining water
from the cavity
embossment.

Setting the DURATION

1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or
time.
The display shows
4. When the time ends,
an acoustic signal sounds. The
appliance deactivates automatically.
5. Press any button to stop the acoustic
signal.
6. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
Progress 9
to set the DURATION
.
flashes and