Working Without The Automatic Leveller; Working With The Tripod; Adjusting The Tripod - Parkside Performance 506427 2507 Bedienungsanleitung

˜ Working without the automatic leveller
ATTENTION! The magnetic surface used should be flat
m
and not curved or uneven surface . Otherwise, the product
will fall down and will be damaged .
INFO:
The leveller light
working without the automatic leveller . The laser lines
depicted are not levelled .
The product has 2 magnets
to attach the product to surfaces that attract magnetic
objects, e .g . steel shelves .
1 . Push the levelling slide switch
2 . Press and hold the V/H button
line and the vertical laser line
[ 1 ]
3 . Activate the 360° laser line
Briefly press the V/H button
4 . Activate the vertical laser line
Briefly press the V/H button
5 . Switching off: Press and hold the V/H button
leveller light
laser line
18 ] [
˜ Working with the tripod
(Fig . B)
Screwing the laser onto the tripod mount
Screw the internal thread
o
the tripod screw
Removing/inserting the tripod mount
ATTENTION! Do not use excessive force . This may
m
damage the product .
1 . Open the lever
2 . Remove the tripod mount
3 . Place the tripod mount
4 . Lock the tripod mount
˜ Adjusting the tripod
(Fig . C)
INFO: You can use the dragonfly
alignment of the tripod .
1 . Pull the tripod legs
2 . Lock the tripod legs
ring .
9 ] [
Setting the height, tripod feet
1 . Open the snap fasteners
2 . Extend the tripod legs
will illuminate permanently in red when
17 ] [
, the 360° laser line
17 ] [
are deactivated .
[ 22 ]
.
23 ] [
.
6 ] [
19 ] [
19 ] [
by closing the lever
19 ] [
apart .
[ 7 ]
into position with the locking
7 ] [
[ 8 ]
to the desired length .
[ 7 ]
. The magnets allow you
2 ] [
to the right ( position).
14 ] [
until the 360° laser
[ 16 ]
are activated .
18 ] [
only:
[ 1 ]
.
[ 16 ]
only:
18 ] [
.
[ 16 ]
, and the vertical
1 ] [
of the product hand tight onto
in an upward direction .
on the tripod for insertion .
to check the horizontal
[ 13 ]
.
until the
[ 16 ]
19 ] [
.
6 ] [
GB/IE/NI/MT 13