Technical Settings; Reinstallation Mode; Testing The Connection - Danfoss Living Connect Bedienungsanleitung

4. Technical settings

4.1 Reinstallation mode

If the thermostat has been removed from the radiator
UK
and needs to be reinstalled (after being used), it is
necessary to activate installation mode to prevent
DE
damage to the thermostat.
DK
To enter installation mode:
NL
Press until
Press to withdraw the spindle.
M flashes.
Reinstall the thermostat on the valve.
Press for approx. 3 seconds to exit.
Please also refer to section 6 regarding removal of the thermostat from the
radiator valve.

4.2 Testing the connection

Press for at least 3 seconds until
displayed.
Press until
Press to make the connection.
LI disappears when the connection is made.
If no connection can be made, the alarm
and antenna symbols flash together.
Refer to "Troubleshooting" at
www.danfoss.com/living
10
is displayed.
M
is displayed.
LI
is
M
living connect®