Ce - Declaration Of Conformity; Safety Instructions - IKA RET basic Betriebsanleitung

Contents
CE - Declaration of conformity
Safety instructions
Unpacking
Correct use
Operation
Setting the operating mode
Setting the safety temperature limit for
RET basic safety control
Setting the temperature control mode for
RET basic safety control
Assembling the stand
Maintenance
Accessories
Error codes
Technical data
Warranty
CE-Declaration of conformity
We declare under our sole responsibility that this product is in
compliance with the regulations 2006/95/EC and 2004/108/EC
and conforms to the standards or standardized documents DIN EN
IEC 61010-1, -2-010 and DIN EN IEC 61326-1.
14

Safety instructions

EN
Page
For your protection
14 • Read the operating instructions in full before starting up and
14 follow the safety instructions.
16
• Keep the operating instructions in a place where they can be
16 accessed by everyone.
17 • Ensure that only trained staff work with the appliance.
18 • Follow the safety instructions, guidelines, occupational health
18 and safety and accident prevention regulations.
• Socket must be earthed (protective ground contact).
19 • Caution - Magnetism! Effects of the magnetic field have to be
taken into account (e.g. data storage media, cardiac pacemakers ...).
19 • Risk of burns! Exercise caution when touching the housing parts and
20 the heating plate. The heating plate can reach temperatures in excess
20 of 340 °C. Pay attention to the residual heat after switching off.
21 • Ensure that the mains power supply cable does not touch the
22 heating base plate.
23 • Wear your personal protective equipment in accordance with the
hazard category of the media to be processed. Otherwise there
is a risk from:
- splashing and evaporation of liquids
- ejection of parts
- release of toxic or combustable gases.
• Set up the appliance in a spacious area on an even, stable, clean,
non-slip, dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
• Check the appliance and accessories beforehand for damage
each time you use them. Do not use damaged components.
• Gradually increase the speed.
• Reduce the speed if
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the container moves on the base plate.
• Caution! Never process and heat up any media that has a flash
point higher than the adjusted safe temperature limit that has
been set (50 to 360 °C).
092008