SATA HRS Betriebsanleitung Seite 31

Operating Instructions for SATA HRS
US
10.4. Replacing the inlet valve
Removing the inlet valve
■ Unscrew and remove pressure cup [1-4] / [1-7] / [1-13]; this simultane-
ously bleeds the pressure spray gun via the cup threading.
■ Unscrew inlet valve [3-8] and remove from gun body [3-9].
Installing the inlet valve
■ Screw inlet valve [3-8] into gun body [3-9].
■ Screw pressure cup [1-4] / [1-7] / [1-13] onto gun body.
11. Care and Storage
11.1. Storage
Notice!
Damage to property due to incorrect storage
Intense sun exposure and very high storage temperatures will damage
the plastic pressure cup.
→ Protect plastic pressure cups against intense sun exposure.
→ Do not store plastic pressure cups at temperatures above 50 °C.
→ Do not store gun with contents still inside.
→ Clean, dry and remove all residue from gun before storing.
11.2. Cleaning the pressure spray gun and wand
Danger!
Risk of injury due to loose components
Components could unexpectedly come loose when performing work on
a pressure spray gun that is connected to the compressed air circuit.
→ Disconnect the pressure spray gun from the compressed air supply
prior to performing any work.
Notice!
Damage to property due to improper cleaning
Immersion in solvents or cleaning agents, or using an ultrasonic cleaner
can damage the pressure spray gun.
→ Do not place the pressure spray gun in solvents or cleaning agents.
→ Do not clean the pressure spray gun with an ultrasonic cleaner.
■ Unscrew and remove pressure cup [1-4] / [1-7] / [1-13]; this simultane-
486