The packing materials (plastic bags, expanded polystyrene, etc.) must be kept out of the
•
reach of children or disabled persons since they represent potential sources of danger.
The installation/assembly of the device will be made/ or according to the indications of the
•
manufacturer. A wrong procedure may cause damages to persons, animals or objects, for
which the manufacturer cannot be considered responsible.
Place and use the device on a horizontal and stable surface.
•
Before use check the integrity of the device and power cable. In case you are not sure
•
contact a qualified person.
Before powering the device make sure the rating (voltage and frequency) corresponds to
•
the grid and the socket is suitable for the plug of the device.
Make sure the power system is equipped with proper protection according to the law in
•
force.
DO NOT power the device using multiple sockets.
•
If possible, avoid the use of adapters and/or extension cables; if their use is absolutely
•
necessary, use only materials in compliance with the current safety regulations and
according to the electrical parameters of the adapters.
The device must not be switched on using external timers and/or other remote control
•
devices which are not specified in this manual.
DO NOT use or store the device near heat sources (heaters, stoves etc.).
•
DO NOT dip the device in water or other liquids; in case the accidental fall in the water DO
•
NOT try to take it out, but first of all unplug immediately the power cable from the socket.
If you use the device for the first time, make sure to remove any label or protective sheet
•
which blocks its proper functioning.