Maintenance Of The Fan(S); Fire With Central Heating Connection; Maintenance; Cleaning - Dik Geurts Bora EA Bedienungsanleitung

5.5.2 Maintenance of the fan(s)

Dust and dirt in the room where the appliance is installed can have a negative effect on the operation of the fans.
We therefore recommend cleaning the fans periodically.
To do this proceed as follows:
•
•
•
•
•
Consult your supplier if the fan is not working as desired.
Only perform maintenance after the fire has cooled down completely.
!Tip

5.6 Fire with central heating connection

In the installation/user manual, which is supplied separately with the fire, the operation of the fire with the central
heating connection is explained.

6. Maintenance

Dik Geurts fires are made of steel plate. A lot of attention is given to a sound manufacture and careful finish, as a
result of which your fire requires little maintenance. The following maintenance tips/instructions contribute to a
proper operation of your fire and therefore your comfort of use.
•
!CAUTION
•
•
•
Slightly open the fire door when you are not burning. This will prevent condensation and possible corrosion.
!Tip

6.1 Cleaning

You can clean your fire whenever you want.
Ø
Clean the outside of the fire with a soft duster.
•
!Caution
•
•
Ø
Remove any deposits on the glass pane using the supplied glass pane cleaning agent. For this, observe the user
manual on the packaging (see section 6.6). The glass pane cleaning agent is available via your supplier/installer.

6.2 Paint

Damages to the paint, resulting from objects that have fallen/been placed against the casing of the fire, are not
!Caution
covered by the warranty.
Small damages to the paint you can repair yourself, using the supplied spray can. It will be available via your
supplier/installer.
If, nevertheless, a rust spot appears on your fire, you can remedy this as follows:
Ø
Carefully sand the rust spot with steel wool.
Ø
Then treat this area with the supplied paint. Prior to this, you should check whether the colour indicated on the
spray can corresponds with the fire. In case of doubts, please contact your dealer.
Ø
Make sure the direct vicinity of the fire is covered, because of possible excess spraying.
UK
Disconnect the adapter from the wall socket.
Open the door.
Remove the upper screws that are used to mount the grates (see appendix 2, fig. 8)
Remove grates.
Carefully clean the fan blades using a vacuum cleaner and a dry cloth/brush.
perform maintenance after the fire has been out of operation for at least 24 hours;
do not make any changes to the fire yourself;
as a user you are only allowed to perform the maintenance stated in this chapter, for any other work you will
have to consult an installer who has experience in the field of wood fire heating;
only replace parts by original parts. These are available via your supplier/installer.
do not use corrosive or abrasive cleaning agents when cleaning your fire and/or glass pane, in order to prevent
damage;
do not use water when cleaning, as the heat-resistant paint is not water repellent. Water may cause rust spots;
do not put glasses, cups, etc. on the fire. Rings may cause rust spots.
US E R MA N UA L