Supplementary Installation Instructions Per Appliance; Vidar Wall; Placing The Appliance; Installing A Protective Plate For The Plasterwork - Dik Geurts Vidar Triple Installationsvorschrift

IN S TA LLA TION M A N U A L

9.5 Supplementary installation instructions per appliance

9.5.1 Vidar Wall

9.5.1.1 Placing the appliance

This appliance should be installed as suspending from a wall.
The Vidar Wall should only be mounted to a vertical wall made of solid, non-combustible and heat resistant
!CAUTION
material.
The flue exhaust (niche pipe or connecting piece suitable for stainless steel pipe 150 mm) in the ceiling should be
!Caution
190 mm from the wall, measured from its centre. In all other cases, you must use bends.
When placing the fire, please proceed as follows (see Annex 2, fig. 13):
Ø
Mount the wall plate. The recommended height is 930 mm (A), measured from the top of the wall bracket
(= 450 mm (B) from the bottom of the appliance to the floor)).
When attaching the wall plate, maintain aminimumheight of 780 mm (A) (= 300 mm (B) from the bottom of the
!Caution
appliance to the floor))!
Ø
Attach the wall plate with the supplied key sleeves and key bolts. Make sure everything is mounted level and that
the wall plate is centrally located under the flue exhaust in the ceiling.
Prior to placing the appliance, remove the front door and flame baffle plate in order to avoid damages and ease
!Tip
installation.
Ø
Suspend the appliance over the lip of the wall plate and adjust the fire using the spacers at the back.
Ø
Place the flue pipe and possible rosette.

9.5.1.2 Installing a protective plate for the plasterwork

If the appliance is placed against a plastered wall or a wall with light coloured paint/wash, we recommend
installing the supplied protective plate for the plasterwork. Without this plate, the plasterwork or paint/wash can
be damaged due to high temperatures.
Proceed as follows:
Ø
Allow the protective plate at the back of the flue duct to rest on the appliance.
Ø
Then press the plate against the flue duct.
Ø
Drill 4 small holes (Ø 4 mm) and fix the plate using the supplied screws (see Annex 2, fig. 14).

9.5.1.3 Connection of the flue

In case of the Vidar Wall, the flue can be connected in two ways: drained or non-drained. For this you will have to
use the specially developed conical ring. The required connecting pieces are available through your supplier.

9.5.2 Vidar Triple

9.5.2.1 Placing the appliance
In order to promote a stable set-up, the Vidar Triple is provided with two adjustable feet (see Annex 2, fig. 15).
They are located at the front of the casing and can be adjusted.
9.5.2.2 Connection of the flue
In case of the Vidar Triple, the flue can be connected in two ways: drained or non-drained. For this you will have to
use the specially developed conical ring. The required connecting pieces are available through your supplier.
41