Taking Into Operation; For The First Time; Fastening The Cold (Door) Handle; Protection - Dik Geurts Bora EA Bedienungsanleitung

USER M ANUA L
Use the supplied ash scoop (see Appendix 2, Fig. 1). Never throw the ash directly into the normal waste bin, but put
in a steel bucket and place it on an incombustible floor. Even after a few days, the ash can still be glowing.
Ash from pure (untreated) and clean wood is a natural product. You can use it as a soil improver. In all other cases,
dispose of the ash in the correct way.
Make sure there is always at least 2 cm of ash on the fire bottom. This will improve the combustion and protect the
!Tip
fire bottom.
Never use a vacuum cleaner to remove the ash from the fire. The dust bag is highly combustible and the ash may
!CAUTION
damage the motor.

4. Taking into operation

4.1 For the first time

Prior to taking the fire into operation for the first time, please observe the following:
• The outside of the fire must be clean. If necessary, clean it first with a duster. Contaminations on the fire such
as (building) dust, grit, residues of packaging material and stickers can result in odour and singing hazards or
burns in the paint of the glass pane.
Remove fingerprints from the glass pane with a window cleaning agent.
• The paint of the fire has not yet hardened. Hardening will take place when burning the fire for the first time.
The paint will first become soft before it starts to harden. Until that moment the paint is easily damaged.
Hardening takes place with an unpleasant odour and the generation of white smoke, resulting from the
evaporation of volatile components. Burn the fire (see chapter 5) properly for a few hours so that the paint
really hardens.
• The fire will only start to burn really well after it has been burning a few times. The first few times the glass
pane will steam up a little bit more due to the evaporation of various materials and the lower combustion
temperature. This lower temperature is caused by the fact that insufficient ash has been created.
Do not touch the fire during hardening in order to prevent damaging the paint.
!Tip
Vent the room properly because of the evaporation of heat resistant paint.
!Caution
Remove pets from the room because of the released vapours when hardening the paint.
!CAUTION

4.2 Fastening the cold (door) handle

If your appliance is provided with a stainless steel, detachable (door) handle (see Appendix 2, Fig. 2), you will also be
able to fasten it.
To do this proceed as follows:
Ø
Open the door.
Ø
Place the stainless steel handle in the correct position in the door (see Appendix 2, Fig. 2).
Ø
Rotate the (door) handle in such a way, that the head of the adjusting screw points in your direction.
Ø
Use an Allen key to fasten the adjusting screw (be careful, overtightening will cause breakage).
Now the (door) handle is locked to the door.
If you want to disassemble the (door) handle you should perform the above-mentioned steps in opposite order.

4.3 Protection

In order to prevent unsafe situations, you must carefully observe the following measures/instructions.
• The minimum distance between the fireplace/chimney pipes and combustible objects/materials stated on the
!CAUTION
data plate should be taken into account;
• Do not place combustible materials under the appliance;
• Do not dry clothes, towels, etc. on or near the fire in order to prevent fire;
• Avoid contact with a burning fire in order to prevent burns and/or clothes catching fire;
• When operating the fire, always wear the supplied glove;
• Do not leave children and persons who are unable to judge the consequences of their actions by themselves
near a burning fire;
• Avoid working with solvents, glue, PUR foam, etc. in the room where the burning fire is installed.
UK