Settings; Working Instructions - Parkside Pert 550 C6 Bedienungsanleitung Und Originalbetriebsanleitung

Adjusting the cutting angle
Changing the cutting angle allows you
to trim grass at places that are di cult
to reach, e.g. under benches or wall
o sets.
Press the push button
motor housing and tilt the telescopic
tube . There are 6 possible
[ 7 ]

settings.

Adjusting the handle section
The handle section
90°.
Slide the latch
5 ] [
rotate the handle section
latches into the desired position.
Ad usting the spacer brac et (flo er
protection)
The spacer bracket
trimming assembly away from plants
and trunks not to be cut.
Push the spacer bracket
When the spacer bracket is not in
use, you can move it back to its
parking position.
Extending the cutting line
NOTE
Check the cutting line regularly for
u
damage. Make sure the cutting line
has the length specified by the line
cutter .
[ ]
The product is equipped with a dual
line auto-feed mechanism.
The lines extend automatically every
time the product is switched on. For
proper functioning of the automatic
line extension mechanism, the
line spool must have stopped
[ ]
completely before you restart the
product.
on the
[ 8 ]
can be rotated by
[ ]
upwards and
until it
[ ]
keeps the
[ ]
forward.
[ ]
If the lines are initially longer than
the cutting diameter, they are
automatically shortened to the right
length by the line cutter
If no line ends are visible: Replace
o
the line spool
[
line spool").
Setting the line length manually:
o
1. Disconnect the product from the
mains supply.
2. Press the lock button
it and pull the line ends out a little
bit. Repeat this process until the
line ends protrude slightly beyond
the line cutter
˜ Working instructions
WARNING! Risk of injury!
m
Do not cut moist or wet grass.
u
Before switching on the product,
u
make sure that the line spool
does not touch any stones, scree,
or other foreign objects.
Switch on the product before you
u
approach the grass that is to be
cut.
Do not overload the product during
u
operation.
Avoid contact with obstacles
u
(stones, walls, fences, etc.).
Otherwise the line spool
out quickly.
Avoid using the product in bad
u
weather, especially if there is a
danger of lightning.
Do not select a position for the
u
auxiliary handle
to the upper handle
you cannot control the product
properly.
(Fig. D).
[ ]
(see "Replacing the
]
, release
[ ]
.
[ ]
[ ]
wears
[ ]
that is too close
[ ]
. Otherwise
[ 1 ]
GB/IE/NI/CY/MT 37