Leister VULCAN SYSTEM Bedienungsanleitung Seite 19

Technical data for interface
Relay output
CAUTION : When fixing the tool into an installation, the mains connection must have a suitable de-
vice for disconnect all poles from the mains with a 3 mm distance between contacts.
Alarm contact: SPST– NO 250 VAC / 30 VDC, 3 A cos = 1
Technical data internal dip switch
Open Loop or Closed Loop
Setpoint setting
Potentiometer or
interface
Max. voltages
Max. currents
Max. contact resistance
Relay contact
Insulation IEC/EN 60065
Power setting function
Temperature control function
Internal potentiometer
Interface
AC 250 V, DC 30 V
AC 3 A, DC 3 A
100 m Ohm at DC 6 V / 1 A
SPST - NO
AC 2000 V (50 - 60 Hz) 1 min
Setting level OFF...100 %;
1% steps
Setpoint value specification
50 °C...650 °C, 5 °C steps
Setpoint value OFF...100 % or
50 °C ...650 °C
Setpoint value OFF...100 % or
50 °C ...650 °C
19