Troubleshooting - Fahl NEBUSTEAM Gebrauchsanweisung

7.0 TROUBLESHOOTING

EN
The NEBUSTEAM
arise, you may possibly be able to rectify it yourself if you observe the following instructions.
Symptom of malfunction
Lamp is not lit
No steam output
Steam leakage
Inhaler was subjected to a thorough inspection prior to delivery. Should a malfunction nevertheless
®
possible cause
1. Check whether power cord is well
connected to the electrical outlet
2. Check whether power switch is at "I" status
3. Check whether the device was switched off
due to overheating
1. Check whether lamp is lit
2. Check if there is no water in heater or
furnish tank
3. Check if the suction tube is bending
4. Check if the nozzles are blocked
1. Check if the heater tank cover is firmly
locked
2. Check if nozzle is firmly locked
remedy
1. Firmly insert power cord
2. Stellen Sie den Drehschalter auf die
Position "I".
3. Disconnect the power cord and allow the
device to cool down (30 minutes) and then
set the ON/OFF switch to position "I".
1. Insert power cord and switch the POWER
ON / OFF to the position "0".
2. Fill water in the heat tank.
3. Correct the position of the suction tube.
4. Clean the steam nozzle/jet.
1. Check if the heater tank cover is firmly
locked
2. Check if nozzle is firmly locked
42