HOMCOM 370-013 Bedienungsanleitung Seite 7

Assembly Steps
5
Ø10
locknut
Ø10
Front
washer
hubcap
6
BATTERY INFORMATION
Batteries may leak fluids that can cause chemical burn injury or ruin your product. To avoid battery leakage:
● Non-rechargeable batteries are not to be recharged.
● Rechargeable batteries are to be removed from the toy before being charged.
● Rechargeable batteries are only to be charged under adult supervision.
● Different types of batteries or new and used batteries are not to be mixed.
● Batteries are to be inserted with the correct polarity(+ and -).
● Exhausted batteries are to be removed from the toy.
● The supply terminals are not to be short-circuited.
Front
wheel
Front axle
Front hubcap
washer
● Remove one Ø10 locknut and one Ø10
washer from the front axle with a spanner.
● Insert the tabs on the front hubcap into the
slots in the front wheel.
● Repeat this procedure to attach the other
front hubcap to the front wheel.
● Fit and hold the front wheel to the front
fork, and line up the holes in the front fork
with the hole in the front wheel.
Ø10
● Insert the front axle through the front fork
locknut
and the front wheel.
● Slide a Ø10 washer onto the front axle,
Ø10 and fit a Ø10 locknut to the end of the front
axle. Tighten the locknuts on both sides of
front axle with two spanners. DO NOT over
tighten.
● Remove the screw in the battery
compartment door on the handle bar using
a screwdriver and lift to open.
● Insert three "AA" (LR6) alkaline batteries
as indicated inside the battery
compartment.
● Replace the battery compartment door.
Note: This product does not Includ
the "AA" (LR6) alkaline batteries.