Inserting / Replacing Batteries; External Power Supply; Operation - VOLTCRAFT TS-500 Bedienungsanleitung

Inserting/Replacing Batteries
For operating the desktop scales you need three mignon cell batte-
ries (type AA). When the batteries are low, the display shows "LOW
BAT" (5). If you see this display replace the batteries immediately,
since exact measurings cannot be guaranteed with low batteries.
For inserting/replacing batteries, proceed as follows:
1. Slide the battery compartment cover (9) into the direction of the
arrow to open it, and lift the cover.
2. Remove the used batteries and replace them by three new batte-
ries of the mignon-cell type (AA). Make sure they have the correct
polarity (see illustration in the battery compartment).
3. Close the battery compartment and slide it back until it locks.
Keep batteries out of reach of children
Always make sure the batteries are inserted in the
correct polarity. Batteries inserted in the wrong way
can destroy the scales. Any claims for warranty will
be voided in this case.
If you intend not to use the scales for a certain time,
remove the batteries and keep them separately, lea-
king battery acid might destroy your scales.
Do not leave batteries littered because children or
pets might swallow them. Leaky or damaged batte-
ries might cause cauterization when in contact with
the skin.
Do not short-circuit batteries. Do not throw batte-
ries into fire or try to recharge standard batteries
because they might explode!
18
Environmental Note
In Germany the consumer is legally bound (by the used battery
decree "Batterieverordnung") to return any used battery or rechar-
geable battery; it is forbidden to dispose of batteries with the hou-
sehold garbage.
You can return your used batteries in all our subsidiaries or in the
headquarters in Hirschau, or bring them to the local disposal institu-
tions that are obligated to take them back. Participate in environ-
mental protection!

External Power Supply

The adapter should have the following technical specifications:
Input voltage:
Output voltage:
Plug:
External diameter:
Internal diameter:
Note
Remove the batteries first.
Connect the adapter cable to the socket (8) at the side of the hou-
sing and then connect the adapter to an outlet of 230 Volt / 50 Hz
(10/16A).

Operation

The scales are ready for use immediately after they have been swit-
ched on. However, it is useful to let them warm up for about 1 minu-
te to allow the measured value to stabilize. No loads must remain on
the weighing plate (2) permanently.
230 Volt / 50 Hz (10/16A)
4.5 Volt DC / 300 mA
5.5 mm
2.1 mm
Middle is "+" plus.
19