Operating Elements - VOLTCRAFT TS-500 Bedienungsanleitung

Operating Elements

1
2
3
4
7 6 5 12
1 Protective cover
2 Weighing plate
3 On/off button
4 MODE button
5 Low bat(tery) display
6 Minus sign for "negative" weight
7 Zero display
8 Socket for external power supply
16
8
9
10
11
9 Battery compartment cover
10 PCS button
11 Tare button
12 Weight display
3. Pour the substance you want to weigh into the container. The dis-
play now shows the net weight.
4. To quit the tare function, remove the container and press the
TARE button.
Calibration
The scales have been calibrated ex works. Due to gravity during
transport from the country of production to the location the scales
are taken into operation, accuracy may slightly deviate. To ensure
accuracy of the scales, we recommend to carry out calibrations in
regular intervals, before first use, after abrupt temperature changes
and mechanical strain.
1. Switch the scales off by pressing the on/off button (3).
2. Press the TARE button (11) and keep it pressed down, the ex fac-
tory offset value is now displayed.
3. Press the TARE button again. The display shows "2Ero" and then
the calibration weight required. Now place the respective optio-
nally available calibration weight in the middle of the weighing
plate. The required calibration weigh is different depending on the
type of scales. Please also observe section "Technical Data" at
the end of these operating instructions.
4. Press the TARE button again. The calibration process is now
initiated. The display shows "CAL". After the calibration, the dis-
play shows "PASS".
5. Then press and hold the TARE button. Calibration is now comple-
ted and the scales switched off.
21