Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
You can hold the product in your hand
or place it on the edge of a table.
7.6 Locking and reading data
As soon as the weight on the spoon attachment (1) stabilizes, the digital display will
constantly show the measured value and lock it.
Press the "Hold" button (4) to unlock the displayed measurement. You can then weigh
again.
Press and hold the "Hold" button (4) to switch off the automatic lock function. If "H-oFF"
appears on the display, this indicates that the lock function is disabled, and only the current
weight will be displayed.
Press and hold the "Hold" button (4) again to re-enable the automatic lock function. If
"H-on" appears on the display, this indicates that the lock function is enabled, and the last
measured weight will be locked.
7.7 Automatic power-off
If the product is not used for 1 minute when it is switched on, it switches off automatically.
7.8 Replacing the batteries
The product is powered by two 1.5 V AAA batteries. Replace the batteries when they are empty
in order to continue using the product:
1. Loosen the battery compartment screw on the bottom of the product with a suitable
screwdriver.
2. Open the battery compartment and remove the empty batteries.
3. Insert the new batteries and observe the correct polarity.
4. Close the battery compartment and reinsert the screw.
The product is now ready for use.
Æ
8 Cleaning and care
Important:
– Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions. These may damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Remove the spoon attachment (1) from the product.
2. Clean the spoon attachment (1) with water, such as a washing-up sponge. If necessary,
use washing-up liquid.
3. If the device is dirty, clean it with a damp cloth. Avoid excess moisture and do not exert
strong pressure on the product.
9 Disposal
9.1 Product
This symbol must appear on any electrical and electronic equipment placed on the
EU market. This symbol indicates that this device should not be disposed of as
unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back
of waste. Conrad provides the following return options free of charge (more details on our
website):
in our Conrad offices
at the Conrad collection points
at the collection points of public waste management authorities or the collection points set
up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in
countries outside of Germany.
9.2 (Rechargeable) batteries
Remove any inserted batteries and dispose of them separately from the product. As the end
user; you are required by law to return all used batteries (Battery Directive). They must not be
placed in household waste.
Batteries/rechargeable batteries containing hazardous substances are labelled
with this symbol to indicate that disposal in household waste is forbidden. The
abbreviations for heavy metals in batteries are: Cd=Cadmium, Hg=Mercury,
Pb=Lead (marked on batteries, e.g., under the rubbish bin symbol shown to the left).
Used batteries can be returned to local collection points, our stores or battery retailers. You thus
fulfil your statutory obligations and contribute to environmental protection.
Before disposal, the exposed contacts of batteries must be fully covered with a piece of
adhesive tape to prevent short-circuits. Even if batteries are depleted, the remaining energy
may present a hazard in the event of a short-circuit (bursting, severe heating, fire, explosion).
10 Technical data
10.1 General information
Batteries .......................................2x 1.5 V AAA
Dimensions (L x W x H) ................250 x 58 x 30 mm (default with large spoon)
Weight .......................................... approx. 90 g (incl. batteries and 2 spoons), approx. 66 g
(handle incl. batteries)
10.2 Weighing
Measurement range .....................0.5 - 500 g
Measurement units .......................g / oz / gn / ct
Measurement accuracy:
0 – 100 g: .............................+/-0.2 g
100 – 200 g ..........................+/-0.4 g
200 – 300 g ..........................+/-0.6 g
300 – 400 g ..........................+/-0.8 g
400 – 500 g ..........................+/-1 g
10.3 Operating/Storage conditions
Operating temperature ................. 0 to +40 °C
Operating humidity .......................<75 % RH (non-condensing) at 0 to +30 °C.
<50 % RH (non-condensing) at +30 to +40 °C.
Storage temperature .....................-10 to +50 ºC
Storage humidity ...........................<75 % RH (non-condensing) at -10 to +30 °C.
<50 % RH (non-condensing) at +30 to +50 °C.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE.
*2521585_v2_0422_02_DS_m_4L_(1)
Werbung
Inhaltsverzeichnis
