Eibenstock EBM 182/3 Originalbetriebsanleitung Seite 77

Fixing the core drill motor
Mounting the core drill machine
The machine holder has a special quick connection fixture for the machine
Thereby the prism on the gear box of the machine will be insert from above in the
dovetail fixture of the machine holder and braced firmly by the clamp screw on the
side by means of the turnstile.
For operation with the core drill machine you have to attend the
operating instructions and the safety indications!
In order to operate the tool safely, please observe the following notes:
Details of the work area
Keep the work area free of everything which could obstruct operations.
Provide for adequate illumination of the work area.
Adhere to the regulations concerning the power connection.
Lay the power cable in such a way that any damage by the drill can be
avoided.
Make sure to always keep the work area in view and to be able to reach all
necessary operating elements and safety installations.
Keep other persons away from your work area in order to avoid accidents.
Space requirements for operating and maintenance
Whenever possible, keep a free space for operating and maintenance of about
2 m around the drill position, so that you can work safely and have immediate
access in case of a failure.
Raise the machine holder of the drill rig until it
latches into the end position.
Open the clamp by turning the feed lever until
the clamp releases the guide rail. Insert the
machine into the drill rig as shown.
Secure the machine by tightening the clamp
with the feed lever.
Operations
Wear protective gloves!
Caution! When mounting the machine, risk
of squashing.
16