Eibenstock EBM 182/3 Originalbetriebsanleitung Seite 20

When using the drill, cooling water is never allowed to get into the
motor and all electrical parts.
Overhead-drillings only with suitable safety measures (water collection).
After an interruption of your work, only switch the machine on again after
having checked that the drill bit can be turned freely.
The tool may be used with the drill rig only.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable ear protectors, goggles, helmets, protective gloves and boots.
Always work concentrated and carefully. Do not use the tool when
you are lacking in concentration.
For further safety instructions, please refer to the enclosure!
Fixing to Drill Rig
The EBM 182/3 is made in protection class I. For protection purposes the
machine can only be run with a GFCI. For this reason, the machine is standard
equipped with a PRCD switch integrated in the cord which allows to connect
the unit directly with a grounded socket.
Attention!
! The PRCD-safety switch must not lay in water.
PRCD-safety switches must not be used to switch the
tool on and off.
Before you start working, check the proper functioning
by pressing the TEST button.
The EBM 182/3 is equipped with a special
accomodation for the diamond drill rig BST 182
V/S.
Move the machine holder upwards until it locks in
the top position.
Open the fixing by turning the locking screw with
the feed lever until the guideway is free
Insert the tool into the drill rig.
Fix the tool by turning the locking screw with the
feed lever.
In doing so, the screw must engage the hole in the
v-block.
Electrical Connection
20