Eibenstock EBM 182/3 Originalbetriebsanleitung Seite 21

First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate. Voltage differences from
+ 6 % to – 10 % are allowed.
Only use 3-wire extension cable with protecting conductor and a sufficient
cross-section (min. 2.5 mm
excessive power loss and to overheating of machine and cable.
The machine is equipped with a start-up speed limiter to prevent fast
expulsion fuses from unindented responding.
Water Connection
If the drill bit is not cooled enough with water, the diamond segments could
heat up and consequently get damaged and weakened. For this reason,
always make sure that the cooling system is not blocked.
In order to supply the machine with water, please proceed as follows:
Connect the tool to the water supply system or a water pressure vessel by
means of the GARDENA connector.
Always make sure that the machine only runs with enough clear water as
the seals get damaged when the machine is running dry.
Attention! The maximum water pressure should not exceed 3 bar.
Make sure that the segments are well cooled. If the drilling water is milky,
the segments are well cooled.
Overhead-drilling only with water collection ring.
In case of frost warning, drain the water system.
Changing Gears
1st gear
-1
510 min
2nd gear
-1
1150 min
3rd gear
-1
2500 min
Warning!
! • Only change gears whilst the tool is not in operation!
• Never apply force
• Never use tools, such as hammers or pliers to change the
gear.
2
). A cross-section which is too small could lead to
The EBM 182/3 is equipped with a 3-gear oil-
bath gearing. Select the speed according to the
drilling diameter.
Use the gear selector to change to next higher or
lower gear.
If gear changing is too heavy, slightly turn the
working spindle to ease gear changing.
21