Eibenstock EBM 182/3 Originalbetriebsanleitung Seite 74

After each readjustment always check that the screws are
tightly fixed so that safe operating of the drill rig is possible.
Mounting the turnstile
■ Mount the turnstile (1) on
the right or left side of the
carriage (2) depending on
the work to be performed.
■ Check whether the turnstile
(1) is fixed tightly.
Fastening of the drill rig
Hole centering indicator:
The drill rig is fitted with a hole centering indicator for easy and precise
positioning.
Fastening by means of dowels in concrete
C
Use
Mark the center of the hole to be drilled.
Fully extend the hole centering indicator (see fig.).
Position the drill rig in such a way that the tip of the indicator
points precisely to the hole center mark.
After the drill rig has been fastened, put the hole center
indicator back in its original position.
Mark the position of the drill holes for the
fastening on the surface to be drilled.
D
Drill a hole (Ø 15) 50 mm deep (A), into which
the dowel M12 (B) is to be placed; insert and
secure the dowel with the doweling tool (C).
Screw the quick action clamping screw (D) into
the dowel.
B
A
2
For brickwork, Rawl-Dowels must
be used (drillhole - Ø 20mm).
13
Klick
1